Grid Tie Inverter for Wind Turbine
Model: SUN-500G_WA
Build In Rectifier
Build In High Wind Protection
Preface
The grid-tie inverter can transfer wind energy from wind generators directly into the home grid using no extra equipment. It can be connected to any outlet (conventional network) in the home. The grid-tie inverter controls the phase and the frequency and voltage of the power generated by the wind generator. It produces a pure sine-wave and matches that of the grid.
This model grid-tie has build in bridge rectifier, it has a high voltage protection function, when the wind is too big, and the dump load controlling system can’t keep the output voltage from the wind turbine, the controller will disconnect itself from the wind turbine, so it is very safe to be used.
Layout
There are 3 red terminals will be connected to the three phase output from the wind turbine.
There are 4 LED indicators, 3 green indicators and 1 red indicator, 3 green LED indicators will start to cycle from left to right when the grid and AC input supply is detected. This indicates the inverter is operating under normal condition. The rate of the cycling is according to how much power is being output from the wind turbine. The bigger the output power is, the faster the rate is. If there is no AC grid detected, the red LED will be on, the inverter will not put out power, this is called “Island Protection”.
Electrical Specifications:
WA-----------AC INPUT
WD-----------DC INPUT
Mechanical Specifications:
|
N.W
|
3.5Kg
|
|
G.W
|
4.0Kg
|
|
Dimension
|
332mm*265mm*135mm
|
Operating Temperature Range
-10 ~ 45 degrees C
|
